Before we start it is important that you copy
ALL THE SCREENSHOTS
As they are shown. It will take a little time, but it will be worth it in the end
Open your licensed copy of Mach3. You can drag and drop the images below to your home screen and save them for future reference if required.
Go to > config > select native units > select MM or Inches > OK
Mine are set to MM
Go to > config > select ports & pins > port set up > enable
port 1 > 0x378 > kerel speed > 35000 hz > Apply
Close and restart Mach3
Go to > config > select > motor outputs
Copy this information into Mach3 > Apply
Go to Input Signals on the top tool bar of that screen and copy into Mach3 > Apply
Scroll down
Go to Output Signals on the top tool bar of that screen and copy into Mach3 > Apply
Go to Encoder/MP'S on the top tool bar of that screen and copy into Mach3 > Apply
Go to Spindle Set-up on the top tool bar of that screen and copy into Mach3 > Apply
Go to Mill Options on the top tool bar of that screen and copy into Mach3 > Apply
Now go to config > save
Go to > config > Motor Tuning. Start with the X axis, copy the information. then save axis settings. Do the same for Y, Z, and Spindle
then > OK
Go to > config... Save
Go to > config... General Configuration. Copy these settings into Mach3
Save
Go to > config > Home/Limits Copy these settings into Mach3
Note: the Z axis has a negative value.
Speed % 40 will give you a homing speed of F600
Save
Go to > config > Pulley Selection Copy these settings into Mach3
Note. Your max spindle speed may be different from mine
Save
Go to > config > Global Settings Copy these settings into Mach3
Save. Now you're all done for the settings.
